The Corner Pocket Pool Table Services

Pool Table Movers, Service, Installers. 30 years.

Greater New England
1-508-254-5671 (tap)


In the Corner PocketPool Table Billiard Felt Replacement Email Us

New replacement Pool Table FeltAwesome change! New pool table fabric - felt, and a general tune-up!


We'll cover the slate and rails with sturdy, fast, clean new fabric - felt

      CHECK OUT SOME COLORS HERE!


Also, we tighten up, and level up everything else.

The first and most utilized technique for joining fabric to the slate is stapling. Notwithstanding, your slate must have a wood backing for this strategy. On the off chance that your slate is upheld, there will be ¾" coating of wood straightforwardly underneath the slate. If not, spray-glue the material to your slate is the following best alternative. Either strategy will function admirably. We will exhibit the sticking strategy, however stapling is basically the same.

Initially, extend your fabric longwise down the table first. Staple the fabric on the end by beginning in the center and working your way to the outside. We as a rule put staples around 2 to 4" separated. Go to the next end and draw the fabric, beginning in the center, as hard as possible. It is vital to get the material as tight as would be prudent. Once your material is attached in the middle, you can begin working your way to the edge. Draw the fabric with square with extend on each force. Consistency is imperative here. A conflicting stretch now may make the balls meander or do unforeseen moves when playing- - certainly an undesirable quality of a pool table.

Second, you would now be able to begin on the more drawn out sides. Begin in the center and work your way to the end. Be mindful so as not to draw to tight on the primary side. This will leave your opposite side too short. The most critical things to recollect when extending fabric is snugness and consistency in the extend. On the off chance that you are utilizing paste, utilize an indistinguishable technique from above. Shower the glue (3M Super 77) around five creeps in from the edge of the table. Just do one end at any given moment. Additionally, splash a similar edge of the fabric. Two edges with stick go together much superior to one. Sit tight for the paste to get tasteless, around 30 seconds, at that point press the material to the slate. Go to the next end and do a similar thing.

Third, When the material is secure, utilize a disposable cutter to cut gaps in the fabric where the rail jolts will come up to the rail. There are three openings between each pocket. Utilize your finger from the base up to locate the correct opening. Never attempt and discover the opening starting from the top. A few tables have more than three openings on the best. A cut in the wrong place may destroy the fabric for the entire table. Once the gaps are done, the pockets are prepared to be cut.



Quick Links

credit cards

Contact Us

72 Stagecoach Road,
Leominster, MA, 01543

1-508-254-5671 (tap)

Monday-Friday: 8-5
Saturday: (emergency)
Sunday: Closed

Service Policy

You are sure to be pleased with your table.

Find Us here:
Free Stuff

Find Us On Yelp
The Corner Pocket Pool Table Services